Difference between revisions of "Medieval Madness"

From PinWiki
Jump to navigation Jump to search
Line 19: Line 19:
  
 
== Game-Specific Issues ==
 
== Game-Specific Issues ==
 +
 +
 +
[[Medieval Madness Castle]]
 +
 +
Worn parts make the castle towers lean. Spares are hard to come by, so fixing this one often requires some DIY effort.
 +
 +
 +
  
 
:Draw Bridge is acting up - <br>Check the pivot points, they get peened by ball hits and can distort and bind. A bit of work to take apart, they can be flattened or filed to make a smooth pivot point again. LTG :)
 
:Draw Bridge is acting up - <br>Check the pivot points, they get peened by ball hits and can distort and bind. A bit of work to take apart, they can be flattened or filed to make a smooth pivot point again. LTG :)

Revision as of 21:17, 22 May 2011

ExclamationPoint.jpg
Note: This page is a work in progress. Please help get it to a completed state by adding any useful information to it.


Manufacturer System Year Model Produced
Williams WPC-95 1997 50059 4,016


Medieval Madness Playing Tips and Rule Sheet

Medieval Madness Shop Guide


1 WPC Specific Issues

See WPC Specific Issues

2 Game-Specific Issues

Medieval Madness Castle

Worn parts make the castle towers lean. Spares are hard to come by, so fixing this one often requires some DIY effort.



Draw Bridge is acting up -
Check the pivot points, they get peened by ball hits and can distort and bind. A bit of work to take apart, they can be flattened or filed to make a smooth pivot point again. LTG :)
Troll carriages. Gravity can loosen the collar from the cage, and cause binding on the up or down movement. You can re-peen it with a cold chisel. Or braze it. The collar is much thicker than the cage so welding won't work, you'd melt the cage.
A common problem is a broken wire on the troll head target. Easiest is to take the whole carriage out of game. Remove the bolt holding it to plunger, unplug the connector. Lift up and wiggle out, lean to one side so long part clears playfield hole. Remove nut on plastic piece and remove. Remove troll target. Cut cable tie. Resolder wire good. Check both wires and diode. Reassemble. Put on new cable tie. Install back into game. LTG :)



Return to Williams WPC page.