Difference between revisions of "Star Wars"
Jump to navigation
Jump to search
(Initial version) |
m (picture upgrade) |
||
| Line 11: | Line 11: | ||
= Game-Specific Issues = | = Game-Specific Issues = | ||
| − | [[File: | + | [[File:de-display-romupgrade.jpg|400px|thumb|left|Before and after shots of the display board after upgrading from the stock board with two 2M ROMs. Notice the removal of the 0 ohm resistor(jumper) at R11]]'''Upgrading to newer, larger EEPROMS''' |
During the manufacturing run of Star Wars two different display controller boards were used. Early versions of the board had the display software installed on two 2M ROMs. Later boards had one 4M ROM installed. To use a 4M ROM with the older display board, remove the jumper at R11. This can simply be cut off the board. This is discussed in a [http://www.sternpinball.com/downloads/sb38b.pdf service bulletin.] | During the manufacturing run of Star Wars two different display controller boards were used. Early versions of the board had the display software installed on two 2M ROMs. Later boards had one 4M ROM installed. To use a 4M ROM with the older display board, remove the jumper at R11. This can simply be cut off the board. This is discussed in a [http://www.sternpinball.com/downloads/sb38b.pdf service bulletin.] | ||
Revision as of 20:16, 17 June 2011
| Manufacturer | Year | Model | Produced |
|---|---|---|---|
| Williams | 1992 | 24 | 10,400 |
Star Wars Playing Tips and Rule Sheet
Game-Specific Issues
Upgrading to newer, larger EEPROMS
During the manufacturing run of Star Wars two different display controller boards were used. Early versions of the board had the display software installed on two 2M ROMs. Later boards had one 4M ROM installed. To use a 4M ROM with the older display board, remove the jumper at R11. This can simply be cut off the board. This is discussed in a service bulletin.