Difference between revisions of "Terminator 2: Judgement Day"
| Line 16: | Line 16: | ||
== Game-Specific Issues == | == Game-Specific Issues == | ||
| − | + | ===Diode "Tie Back" missing causes 8-Driver Board transistor to fail=== | |
| + | [[Image:Terminator2-Q20ViolentExposionCropped.jpg |200px|thumb|right|Q20, with a major malfunction, due to the diode tieback wire connection being missing. <i>Photo Credit: John Wart Jr.</i>]]<br> | ||
| + | Similar to the common problem that Star Trek: The Next Generation encounters, Terminator 2 can lose the "diode tieback" connection, causing Q20 to fail, as pictured on the right. | ||
| + | |||
| + | Without this "diode tieback", Q20 on the driver board WILL be damaged and the associated coil is likely to become locked on and melt. The diode tie-back wire is violet/orange and connects from the coil power side on the drop target assembly coil lug to J122 pin 9 on the driver board. If the solder connection at the coil lug is solid, suspect the wire connection at the J122 IDC connector. Repinning this connection with good a quality crimp-on TriFurcon pin is advised. | ||
| + | <br clear=all> | ||
| − | |||
Return to [[Williams WPC]] page. | Return to [[Williams WPC]] page. | ||
Revision as of 19:34, 14 January 2015
 |
| Manufacturer | System | Year | Model | Produced |
|---|---|---|---|---|
| Williams | WPC-Dot Matrix | 1991 | 50013 | 15,202 |
Terminator 2: Judgement Day Playing Tips and Rule Sheet
Terminator 2: Judgement Day Shop Guide
1 Game-Specific Issues
1.1 Diode "Tie Back" missing causes 8-Driver Board transistor to fail
Similar to the common problem that Star Trek: The Next Generation encounters, Terminator 2 can lose the "diode tieback" connection, causing Q20 to fail, as pictured on the right.
Without this "diode tieback", Q20 on the driver board WILL be damaged and the associated coil is likely to become locked on and melt. The diode tie-back wire is violet/orange and connects from the coil power side on the drop target assembly coil lug to J122 pin 9 on the driver board. If the solder connection at the coil lug is solid, suspect the wire connection at the J122 IDC connector. Repinning this connection with good a quality crimp-on TriFurcon pin is advised.
Return to Williams WPC page.