Medieval Madness

Note: This page is a work in progress. Please help get it to a completed state by adding any useful information to it.

Manufacturer	System	Year	Model	Produced
Williams	WPC-95	1997	50059	4,016

Medieval Madness Playing Tips and Rule Sheet

Medieval Madness Shop Guide

1 WPC Specific Issues

See WPC Specific Issues.

2 Game-Specific Issues

Medieval Madness Castle

Worn parts make the castle towers lean. Spares are hard to come by, so fixing this one often requires some DIY effort.

Draw Bridge is acting up -
Check the pivot points, they get peened by ball hits and can distort and bind. A bit of work to take apart, they can be flattened or filed to make a smooth pivot point again. LTG :)

Troll carriages. Gravity can loosen the collar from the cage, and cause binding on the up or down movement. You can re-peen it with a cold chisel. Or braze it. The collar is much thicker than the cage so welding won't work, you'd melt the cage.

A common problem is a broken wire on the troll head target. Easiest is to take the whole carriage out of game. Remove the bolt holding it to plunger, unplug the connector. Lift up and wiggle out, lean to one side so long part clears playfield hole. Remove nut on plastic piece and remove. Remove troll target. Cut cable tie. Resolder wire good. Check both wires and diode. Reassemble. Put on new cable tie. Install back into game. LTG :)

Draw Bridge motor works but the door will not open or close properly creating an error with credit dot-
Go to test/solenoid menu and check drawbridge motor. Lift the playfield and watch the gear mechaism turn. Check the plastic gears in the drawbridge mechanism. The plastic gear can break off some of the small teeth leaving a gap in the gear that causes it to fail. This part is can be ordered and replaced. This repair can be done from the underside of the playfield but will reqire an extra pair of hands. The green "moat" will have to be removed and then the bride and door mechanism loosed and pulled downward. No desoldering/soldering is required. The gear mechanism does has several small "e" clips that have to be removed and replaced. This repair takes about an hour. Nevus

Return to Williams WPC page.