Search results

...lay was. These holes are numbered, from 2 to 40 . Attention 2 to 17 then a gap ( no holes) and it continues at 25 to 40. First the segments a = 2, b = 4,

...on cabinets with screen printing or decals. They are thick enough to add a gap between the cabinet and the edges of the leg. Metal protectors are mechani

...y Williams with a lightning bolt pattern molded into the top. The flipper gap is larger on games that used these, and the flippers play slightly differen ...al on the playfield is achieved, move together to close the normal flipper gap. Both Bally and Williams used zipper flippers in the 1960s to the early 19

...e playfield. Williams included a tool with their games to get the flipper gap right, but that tool usually gets lost. This tool has been reproduced and

...ng bridged with electricity. The fix for a locked-on relay is to widen the gap between the terminals. Unhook the spring. Remove the switch contacts in the ## Check the switch to make sure there is enough of a gap between the switch contacts.

just shove it in the gap to widen it. The end goal is a “U” shape.

...a notorious example of this, and will be discussed further below. Correct gap on the score motor switches is critical for proper game operation.<br> ...at rides along the edge of the cam, “climbs” out of the notch, closing the gap and making an electrical connection through switch 1 C. When the motor fin

...seats folded down. Head must be put in flat, then tipped vertical at the gap where the back seats folded. Very tight fit for head box. Definitely will

...t down towards the lower edge of the PCB (depending on the size of the air gap between the diode and PCB) in order to accommodate the size of the 9-pin ho ## When installing the diodes, leave a small gap between the component and the PCB so that there is some air flow to help ke

...s need to be filed flat or replaced and should open with between 1/8"-1/4" gap at full extension. Flipper cabinet switches need to be filed and dressed a ...o fit between the targets and the slot and glued into place eliminates the gap that the ball gets stuck in, but this is a very radical solution and not re

...ppropriate. The power resistors should be replaced also with a slight air gap below them to help with cooling. It is possible to approximately double th ...d connections. Use some additional solder and connect the two, bridge the "gap". Now all grounds (J3-18 thru J3-24) are tied together.

...or which led to inoperative coils driven by Q3, Q11, Q19 and Q27 (note the gap between these parts is 8 transistors, the width of the data bus).

...ush with the tops of the bridge rectifiers and that you leave about a 5/8" gap between the bridge rectifier and the board to improve air flow. ...the driver board. In rare cases a frayed wire or a wire with an insulation gap/failure will touch ground and the coil will lock on.

*Insufficient gap between nylon bushing and crank

...broken. A magnifying glass may be necessary to inspect the pins since the gap in the breaks may be extremely small. The outer-most legs are responsible f