All public logs
Jump to navigation
Jump to search
Combined display of all available logs of PinWiki. You can narrow down the view by selecting a log type, the username (case-sensitive), or the affected page (also case-sensitive).
(newest | oldest) View (newer 50 | older 50) (20 | 50 | 100 | 250 | 500)- 15:31, 17 November 2011 Newmantjn talk contribs uploaded File:FinishedOnOff.jpg (The completed installation of the new on/off switch.)
- 15:29, 17 November 2011 Newmantjn talk contribs uploaded File:CableDone.jpg (This file show the lacing. You could also zip tie it.)
- 15:27, 17 November 2011 Newmantjn talk contribs uploaded File:Laceing.jpg (Completed Lacing of the On/Off wiring.)
- 15:21, 17 November 2011 Newmantjn talk contribs uploaded File:CabDone.jpg (Finished cabinet, as viewed from the bottom. Ready for switch installation.)
- 15:20, 17 November 2011 Newmantjn talk contribs uploaded File:HoleSawTop.jpg (Hole saw started from the top. Go half way and then finish from the bottom.)
- 15:18, 17 November 2011 Newmantjn talk contribs uploaded File:ScrewBlock.jpg (Block installed and with a large screw through the middle of it to hold it overnight until the glue dries.)
- 15:16, 17 November 2011 Newmantjn talk contribs uploaded File:GlueBlock.jpg (Block with glue smeared on it and a pilot hole for the clamping screw drilled into it.)
- 15:13, 17 November 2011 Newmantjn talk contribs uploaded File:BlockCutandMark.jpg (A 3" x 5" block of birch plywood, cut and with the center marked.)
- 15:02, 17 November 2011 Newmantjn talk contribs uploaded File:HookUpSwitch2.jpg (The splice on the black wire is almost complete. Just need to slide over the shrink tube and heat it up.)
- 14:56, 17 November 2011 Newmantjn talk contribs uploaded File:RedtoBlacktoBlack.jpg (Wiring of the new switch. The smaller black and red wires, just to the left of the shrink tubing were pulled off the hold relay and soldered together and also to the larger (14 ga.) single black wire coming out of the splice to the right. The lower, lar)
- 14:29, 17 November 2011 Newmantjn talk contribs uploaded File:PowerCordHookUp.jpg (The hook up for a two pronged, polarized line cord. Note that the ribbed side goes to the transformer.)
- 14:25, 17 November 2011 Newmantjn talk contribs uploaded File:StartingPoint.jpg (A typical power cord which requires replacing)
- 20:45, 25 May 2011 Newmantjn talk contribs uploaded File:Coil Sleeves.pdf (What fits what coil sleeve chart)
- 13:07, 23 May 2011 Newmantjn talk contribs uploaded File:RatTrapScoreWheelAssy.jpg (Install the Score Reel)
- 13:04, 23 May 2011 Newmantjn talk contribs uploaded File:RatTrapCircuitBoardAssy.jpg (Install the Circuit Board)
- 13:00, 23 May 2011 Newmantjn talk contribs uploaded File:RatTrapCoilandPlungerAssy.jpg (Assemble the Plunger and Coil)
- 12:55, 23 May 2011 Newmantjn talk contribs uploaded File:RatTrapRatchetandCamAssy.jpg (3.Install the Cam and Ratchet Hub)
- 12:54, 23 May 2011 Newmantjn talk contribs uploaded File:RatTrapDriveIndexPawlAssembly2.jpg (Install the Drive Index Pawl Assembly, spring and E clip)
- 12:50, 23 May 2011 Newmantjn talk contribs uploaded File:RatTrapStepUpPawlInstall.jpg (Install the Stepup Pawl)
- 08:56, 15 May 2011 Newmantjn talk contribs uploaded File:RatTrapMoreSwitches.jpg (Some Score Reels Have More Switches than Others)
- 08:50, 15 May 2011 Newmantjn talk contribs uploaded File:RatTrapCoilStopReplacement.jpg (Replacing the Coil Stop)
- 08:47, 15 May 2011 Newmantjn talk contribs uploaded File:RatTrapCoilNewParts.jpg (Replacement Parts for the Coil and Plunger)
- 08:42, 15 May 2011 Newmantjn talk contribs uploaded File:RatTrapCleanInsideReel.jpg (Clean the Inside with Novus or a Rag Moistened with Mean Green)
- 08:37, 15 May 2011 Newmantjn talk contribs uploaded File:RatTrapReelCleaning.jpg (Clean the Number Surface with Novus 2)
- 08:31, 15 May 2011 Newmantjn talk contribs uploaded File:RatTrapReelCleaningSupplies 033.jpg (Cleaning Supplies Used for Score Reels)
- 08:27, 15 May 2011 Newmantjn talk contribs uploaded File:RatTrapUltrasonic.jpg (Parts in the Harbor Freight Ultrasonic Cleaner)
- 08:24, 15 May 2011 Newmantjn talk contribs uploaded File:RatTrapBottleBrush1.jpg (Clean out the Holes with a Bottle Brush)
- 08:22, 15 May 2011 Newmantjn talk contribs uploaded File:RatTrapMeanGreen.jpg (Hose the parts down with Mean Green)
- 07:57, 13 May 2011 Newmantjn talk contribs uploaded File:RatTrapTeflon.jpg (Use Superlube or a Similar Dielectric Grease - Use Sparingly)
- 07:55, 13 May 2011 Newmantjn talk contribs uploaded File:RatTrapAfterSanding.jpg (Circuit Board After Light Sanding)
- 07:54, 13 May 2011 Newmantjn talk contribs uploaded File:RatTrap600Grit.jpg (Sand with 600 Wet or Dry and Alcohol)
- 07:45, 13 May 2011 Newmantjn talk contribs uploaded File:RatTrapCircuitBoardInitialClean.jpg (Initial Cleaning Done with Synthetic Steel Wool and Mean Green)
- 09:11, 11 May 2011 Newmantjn talk contribs uploaded File:RatTrapStripped.jpg (Rat Trap Score Reel Assembly, Fully Stripped)
- 08:42, 11 May 2011 Newmantjn talk contribs uploaded File:RatTrapRachetandPawl2.jpg (Ratchet and Pawl Removal)
- 08:22, 11 May 2011 Newmantjn talk contribs uploaded File:RatTrapStepUp.jpg (Step Up Pawl removed.)
- 08:14, 11 May 2011 Newmantjn talk contribs uploaded File:RatTrapCoilParts.jpg (Used parts from the coil assembly. Remove the coil by unscrewing the two screws holding the coil stop on.)
- 20:13, 10 May 2011 Newmantjn talk contribs uploaded File:RatTrapBoardAway.jpg (Swing Board out of the way)
- 20:12, 10 May 2011 Newmantjn talk contribs uploaded File:RatTrapDesolder.jpg (Desolder the wire to enable the board to swing out of the way.)
- 20:10, 10 May 2011 Newmantjn talk contribs uploaded File:RatTrapCircuitBoardRemoval.jpg (Remove the two bottom screws)
- 20:03, 10 May 2011 Newmantjn talk contribs uploaded File:RatTrapCamandEclip.jpg (Remove the E clip that retains the Cam and Ratchet Hub Assembly)
- 18:20, 10 May 2011 Newmantjn talk contribs uploaded File:RatTrapRemoval.JPG (Score Reel Assembly Removal)
- 18:18, 10 May 2011 Newmantjn talk contribs uploaded File:RatTrapScrews.jpg (Score Reel Removal)
- 18:11, 10 May 2011 Newmantjn talk contribs uploaded File:RatTrapGroundWheelPokaYoke.jpg (Poka-Yoke assembly feature on the ground wheel)
- 18:06, 10 May 2011 Newmantjn talk contribs uploaded File:RatTrapGroundWheelAssy.jpg (The Grounding Wheel Assembly)
- 17:57, 10 May 2011 Newmantjn talk contribs uploaded File:RatTrapLovinIt.jpg (The Iconic Rat Trap Score Reel. Where engineering and art intersect.)
- 17:55, 10 May 2011 Newmantjn talk contribs uploaded File:RatTrapAfterDegrease.jpg (Circuit Board After Mean Grean Degreasing)
- 20:17, 28 April 2011 Newmantjn talk contribs uploaded File:Volleydrop014.jpg (All Done)
- 20:16, 28 April 2011 Newmantjn talk contribs uploaded File:Volleydrop012.jpg (Back on)
- 20:15, 28 April 2011 Newmantjn talk contribs uploaded File:Volleydrop011.jpg (Another Shot of the Reset Arm Installation)
- 20:11, 28 April 2011 Newmantjn talk contribs uploaded File:Volleydrop010.jpg (Reset Arm Installed)