Uploads by Zitt
Jump to navigation
Jump to search
This special page shows all uploaded files.
| Date | Name | Thumbnail | Size | Description | Versions |
|---|---|---|---|---|---|
| 20:21, 26 May 2012 | DE CN 2F2.jpg (file) |  |
257 KB | Transformer Secondary side w/ burnt 2F2 | 1 |
| 20:49, 26 May 2012 | DE CN1 PPB.jpg (file) |  |
525 KB | PPB CN1 connector burned Pin8 bad Pin1. | 1 |
| 22:25, 1 May 2017 | 10kRComponetSide.jpg (file) |  |
68 KB | STNG Bullet-proof 8Driver board for Tieback. 10k ohm resistor between CLK and +5V. | 1 |
| 22:32, 1 May 2017 | 10kRpackSolderSide.jpg (file) |  |
59 KB | 10k Rpack on Solderside pulling the 8 datalines low. | 1 |
| 22:47, 1 May 2017 | Schematic 8-driver-mod-highlight.png (file) |  |
80 KB | Highlighted schematic showing added resistors. Please consult your users manual for the complete schematics for this board. | 1 |
| 23:03, 1 May 2017 | Stng wingled kbopW.jpg (file) |  |
269 KB | Pinball-Mods.com's DIY PCB set which replaces the bulb sockets with SMT LEDs so they are directed down toward the Playfield. Available in Red, Purple, and Warm White. | 2 |
| 01:05, 25 June 2017 | AS-2518-147 gnd bulletProofing.jpg (file) |  |
310 KB | Steps 1 and 2 of the ground mods for an AS-2418-147 combo solenoid and lamp board. ``image courtesy of Peter @ www.inkochnito.nl'' | 1 |
| 01:19, 25 June 2017 | AS-2518-147 gnd bulletProofing-1.jpg (file) |  |
320 KB | 1 | |
| 01:21, 25 June 2017 | AS-2518-147 gnd bulletProofing-3.jpg (file) |  |
265 KB | Step #3 of AS-2518-147 ground mods. | 1 |
| 01:24, 25 June 2017 | AS-2518-147 gnd bulletProofing-4.jpg (file) |  |
319 KB | AS-2518-147 ground mods; step #4. | 1 |
| 23:38, 5 January 2024 | DuckScanCap.pdf (file) |  |
70 KB | Cap kit available from Digikey for Duckscan CGM-1901CW. | 1 |
