Uploads by Pb123
Jump to navigation
Jump to search
This special page shows all uploaded files.
| Date | Name | Thumbnail | Size | Description | Versions |
|---|---|---|---|---|---|
| 00:41, 10 May 2024 | Bally 6803 PSU R3 R4 closeup for EzSBC mod.jpg (file) |  |
503 KB | This shows the modifications needed to replace the 78H05C VRM with the new EzSBC 5V VRM. No heat sink is required for this new VRM. R4 and R3 are removed. R3 is replaced by a jumper wire, in this case a 22ga wire was used (in blue, to the right of the black capacitor). | 2 |
| 17:27, 8 July 2023 | WMSSystem6ROMConfig.jpg (file) |  |
688 KB | Illustrated needed modification to add 2716 EPROM to IC14, cut J4 (labeled), and add J3 (labeled). | 2 |
| 00:43, 31 December 2020 | SS Bally GI lighting tap 3.jpg (file) |  |
425 KB | Picture showing inside of cabinet, right flipper, before socket mount. I solder the wires to the anode and cathode of the socket, and screw the socket into the side of the cabinet with half-inch screws. I typically use the hex head screws as it's easier to get a grip on it. Don't use long screws! You could damage your cabinet. It's also important to note that I recommend flexible head #44 LEDs (as well as #44 socket of course) because invariably the light won't be exactly where you need... | 1 |
| 00:37, 31 December 2020 | SS Bally GI lighting tap 2.jpg (file) |  |
505 KB | Picture two showing where I stapled down wires coming from the GI socket on the playfield, and where I split it with additional wiring for left and right buttons. Note that from the playfield, I brought the new wiring together with the existing wire bundle from the playfield to keep it neat and orderly. | 1 |
| 00:33, 31 December 2020 | SS Bally GI lighting tap 1.jpg (file) |  |
414 KB | Picture one showing where I tapped into GI lighting for the lighted flipper button mod. | 1 |
| 00:10, 31 December 2020 | PXL 20201104 041722833.jpg (file) |  |
275 KB | Third picture showing switch mounted to coin mech bracket for free play on Stern MPU 100/200 games. Switch wired to coin switch. Be sure to insulate this switch so as not to short out to coin reject. | 1 |
| 00:07, 31 December 2020 | PXL 20201104 050120743.jpg (file) |  |
240 KB | Second picture showing switch mounted to coin mech bracket for free play on Stern MPU 100/200 games. Switch wired to coin switch. Be sure to insulate this switch so as not to short out to coin reject. | 1 |
| 00:05, 31 December 2020 | PXL 20201104 050105388.jpg (file) |  |
264 KB | This is where I mounted, and protected with heat shrink tubing, the leaf switch I connected to the coin switch. Note I drilled two holes as to mount the leaf switch onto the coin mech bracket. | 1 |
